Forum » General Tuning Discussion » Expansion Loom Link g4+

Expansion Loom Link g4+

General Tuning Discussion

Discuss all things tuning in this section. News, products, problems and results. 


Page 1
Author
285 Views

Hi is there another Way to get a innovative lambda to interact with the a pnp Link g4+ without the expansion Loom?

Best regards

Leo

Hi Leo,

I have seen some installs with the OE sensor wire have a bullet connector crimped in so that you can unplug it and plug in the Innovative output wire.

thanks for the answer Chris ! :)

You can repurpose any of the analogue inputs on a plug & play ECU like a Link G4+ depending on your requirements, so yes, you could easily input the Innovate wideband controller. The wiring pin outs and functions are listed in the Link manual so you can decide what to substitute. I'd normally recommend substituting the Innovate for the stock NB input.