Talk about engine building here. New products, tricky questions or showcase your work - If it's engine building related it's welcome here.
| Topic | Posts | Last Post |
|
EJ25 block halves loosening sequence
By Full blown performance on January 15, 2019 at 6:58:32 AM |
4 |
23 hours ago |
|
Knife edging a crankshaft
By RyanC on January 15, 2019 at 12:09:18 AM |
4 |
3 days ago |
|
Sodium filled Valves
By Wessel on January 10, 2019 at 7:10:51 AM |
15 |
4 days ago |
|
Rb25det measurements and clearances
By Joeymcc on November 5, 2018 at 12:24:33 PM |
10 |
9 days ago |
|
Damaged Valve
By The_big_dill on December 30, 2018 at 1:22:58 PM |
8 |
14 days ago |
|
Torque plate
By Jesse james on December 30, 2018 at 8:20:37 PM |
6 |
15 days ago |
|
Using bore gauge
By Adm1982 on January 7, 2019 at 10:12:22 AM |
2 |
15 days ago |
|
Are these Subaru EJ25 crankshaft clearances ok?
By booki89 on December 31, 2018 at 5:00:58 AM |
2 |
20 days ago |
|
Oil rail ring too tight
By nathankong on December 28, 2018 at 8:10:05 PM |
2 |
23 days ago |
|
4G63 Manley piston ring recommendation
By nathankong on December 21, 2018 at 1:35:51 AM |
2 |
27 days ago |