Forum » General Tuning Discussion » Motec m800 12 injectors setting

Motec m800 12 injectors setting

General Tuning Discussion

Discuss all things tuning in this section. News, products, problems and results. 

Page 1

Hello guys i am going to tune an engine that is running on motec cdi 8 with cdi coils, i want to run the engine on 12 injectors, so does the cdi8 act as a expander, if it does what should setting should i put on ign 1?


If you're running a CDI8 then this is wired to IGN 1 and the ignition mode needs to be set to '100'. In this configuration the ignition events are all requested through the IGN 1 output and the remaining ignition channels are available for other purposes.

With a CDI ignition you also need to set your entire dwell table to 1 ms.

Thanks for your fast reply andre, but what i meant is ign 1 should be set like an expander?