Sale ends todayGet 30% off any course (excluding packages)
Ends in --- --- ---
A place to buy, sell and swap HPA course-relevant equipment and supplies. Tuning widgets, wiring apparatus, engine building gizmos, fabrication gear, alignment thingamajigs and more welcome.
Hey all,
My tuning dreams have come to an end, with another round of health issues and back fusions. I am consolidating things from my EV business, including a barely used DAQ55 hub dynamometer from Dynapack.
The unit was purchased new and delivered fully optioned (after all of the supply chain and shipping issues post COVID) in 3/2023 with over a 1.5 year lead time. The units have very few hours, as my priorities shifted in my business on the consulting side. Here are the details:
Four wheel drive chassis dynamometer system.
System power rating 9000nm torque at the drive axles, (2400hp Nominal).
* Option before completion, raise power level to DAQ55 spec 20,000.
System consists of the following; 2 pair 4500nm pods, Cabinet / Controller assembly, Computer, Keyboard, Mouse, Monitor, 2 pair 4 lug universal wheel adapters, 2 pair 5 lug universal wheel adapters, 20 wheel adapter washers.
Shielded Pod Cables. For the prevention of RF interference generated by Electric Vehicle Prototypes. Pair
Misc Inputs. 4 0-20 Volt, 2 EGT, RPM, TPS
Lambda / AFR, High Speed Wideband Unit
Boost Vacuum Transducer
Barometric Pressure Sensor
Humidity Probe
Independent wheel control
Can Bus Logging Module
6 to 5 lug wheel adapters, Chevy / Toyota 6 x 5.5 to 5 lug, Pair
6 to 5 lug wheel adapters, Dodge 6 x 4.5 to 5 lug, Pair
8 lug to 5 lug wheel adapters, Chevy-Dodge 8x6.5 to 5 lug, Pair
8 lug to 5 lug wheel adapters, Ford 8x170mm to 5 lug, Pair
This is a solid business for those who have the back strength for one, but resources to support ECU tuning or calibration work which was my intent. The unit comes with a basic water refrigeration cooler and hosing.
Price: $150,000 / obo
The units are located in Dixon, CA near Sacramento.
Email any questions at [email protected]