Forum » EFI Wiring Fundamentals » Trigger Shielding

Trigger Shielding

EFI Wiring Fundamentals

Discussion and questions related to the course EFI Wiring Fundamentals

Page 1

I am installing some wire in Link ECU's on some Accord CL9 Euro . I am getting trigger signal and everything on the run screen seems ok , except that although I think I have wired correctly the intake cam sensor , I do not have a signal to that unless I crank the engine , while the exhaust has constantly signal . And I also get error counts . I have followed the steps in the help file to set it up , so I believe I am ok in that area . I haven't although used the shield ground as on these cars neither trigger (crank or cam) is shielded . Could that cause an issue .

Also on 1 of these cars although it's drive by wire we will be using the monsoon . Can I use all the features except the tps or do I have to connect tps signal to make it work ?

Thank you