Sale ends todayGet 30% off any course (excluding packages)
Ends in --- --- ---
Forum Posts
Courses
Blog
Tech Articles
Discussion and questions related to the course PDM Installation & Configuration
= Resolved threads
Hi, I'm trying to control a linear actuator using my AIM PDM 32 and for this i wish to create a full bridge using 2 half bridges.
Unfortunately the PDM manual is not very helpful with regards to connecting the 2 half bridges so that they act like a full bridge.
Any assistance would be greatly appreciated.
Many thanks
In Race Studio 3 when configurting the Power Outputs, click the little "link" icon on the HBxx line to link two half bridges and configure the "Two Half Bridges" operation.
Hi David, thanks mate I feel a bit dumb now.
Really appreciate the quick response.
I had no idea how to do it either. But I've been working with Aim for 20 years, so I kind of know what to look for in their software... At least they offer "tool tips" so if you hover your cursor over an icon, it will indicate what it might promises will do. Ready, Aim, Click!
Thanks again David
