sourcing harness materials, cross referencing crimp tools to connectors

I am just starting a simple EFI/EDIS harness. I have taken the fundamental and club harness courses and am trying to assemble the necessary bits and gubbins. I have a "tool Aid" replaceable jaw ratcheting crimper, suitable for open barrell, insulated and bare terminals, It says it will work with weatherpack.

I am way up in northern california on the coast, looking for a relatively close supplier for DR25 and Raychem HCL and once i figure out what connectors i have, a pinning/depinning tool.

I've got a start with the engine out and am doing layout, full scale on a paper covered work table.

Any advice welcome,

thanks,

chris

I actually source a lot of stuff from ProWire in the US. They have a great selection and have been extremely good to deal with. They should have most if not all of your needs covered.