A roll cage is the one part of your car you hope never has to do its job. But, if it does, the planning, the fit of every joint and the quality of every weld all matter at once. That’s why a cage needs more than the ability to weld.
It needs a clear process from the first design, measurement, bending, notching, welding and final sign-off, yet most of the information required to build a cage is scattered; that's where this course comes into its own.
This course walks you through that complete process for both weld-in and bolt-in cages. You’ll start by planning the cage around the vehicle, the driver and your governing body’s regulations, then select the right tube materials, welding process and fasteners for the job. From there you’ll build a cutting list, then measure, order and cut tube to length.
You’ll also learn to prepare the shell, removing sound deadener, seam sealer, paint and spot welds where the cage needs to sit. Then comes the fabrication itself: accurate bends using the bend template method, including multi-plane bends; notching with hole saw, template and abrasive methods; and fitting, clamping and tacking every joint before it’s welded.
Once the structure is in place, you’ll template and fabricate the gussets and footings, complete full 360-degree welds and weld the cage into the chassis. Finally, you’ll check your bends and welds against sign-off requirements through your governing body — before painting, padding the cage and refitting the interior, seats, harnesses and windows.
This course builds on welding ability you already have. It focuses on cage-specific fabrication rather than teaching MIG or TIG welding itself.
Need to build those skills first? Check out our Practical TIG and Practical MIG Welding courses here.
By the end of Roll Cage Design & Fabrication, you’ll be able to...
- Plan your cage around your car. Lay out a cage to suit the vehicle, the driver’s position and the regulations you need to meet.
- Choose the right materials. Select tube, welding process and fasteners to suit the application, and cut everything to length from a cutting list.
- Prepare the shell properly. Remove sound deadener, seam sealer, paint and spot welds so the cage sits and welds correctly.
- Bend and notch tube accurately. Use the bend template method for single and multi-plane bends, and notch tube with hole saw, template and abrasive methods.
- Fit and weld the structure. Fit up, clamp and tack each joint, fabricate gussets and footings, and complete 360-degree welds into the chassis.
- Finish it ready for sign-off. Check bends and welds against sign-off requirements, then paint, pad and refit the interior.
Who it's for...
This course is for anyone who can already weld and wants to build a roll cage properly, whether for their own track or race car or as a service in their workshop.
- Enthusiasts building a cage for their own track day, club or race car
- Fabricators who want a complete, repeatable process for weld-in and bolt-in cages
- Workshops looking to bring roll cage work in-house
Before you start
This course assumes you can already:
- Set up a welder and produce sound welds on steel
- Prepare and fit up joints ready for welding
